JUMO Wtrans E01, Руководство по эксплуатации

Страница: 9 / 64

9
1 Introduction
1.4 Connection elements
1.4.1 View from below
1.4.2 View from above
(1) (2) (4) (3)
(1) Connection for sensor 1: sensor for humidity and temperature, sensor for CO
2
, or RTD tempera-
ture probe Pt1000
(2) Connection for USB connector (Mini-B): if the interface is not needed or after a configuration, the
opening on the device must be sealed using the sealing screw M12 × 1.5 supplied (accessories
set) with the help of the mounting key (accessories set).
(3) Connection for external voltage supply: if the voltage is supplied externally, the cable fitting sup-
plied (accessories set) must be used instead of the M12 × 1.5 sealing screw. Install the cable fit-
ting instead of the sealing screw labeled with (3).
(4) Connection for sensor 2: sensor for humidity and temperature, sensor for CO
2
, or RTD tempera-
ture probe Pt1000
(5)
(5) Connection for lambda/4 antenna, or optionally lambda/4 antenna with antenna cable and anten-
na holder for wall mounting