JUMO 202580, Руководство по установке

Страница: 53 / 82

53
17 Calibrating u
niversal inputs
17.1 Important information
17.2 General information
17.2.1 Calibration methods for universal inputs
Universal inputs can be configured with various operation modes for a number
of different process variables (see table below).
Detailed information on the possible configurations:
v
Chapter 9.5.2 "Universal inputs of base unit and optional boards", Page 99
Appropriate calibration routines for each operation mode of a universal input can
be enabled in the calibration default settings.
The following table lists the availability of calibration routines for the individual
operation modes.
Zero-point calibration
This calibration method is used to determine the pH zero point on a measure-
ment characteristic curve. The slope is retained.
A test solution with a defined value of the respective process variable is needed
as a reference.
Slope calibration
This calibration method is used to determine the slope of a measurement char-
acteristic curve. The zero point is retained.
A test solution with a defined value of the respective process variable is needed
as a reference.
WARNING!
During the calibration, the relays and analog output signals assume the config-
ured states!
linear
scaling Temp. mea-
surement pH value
measure-
ment Conductivity
measure-
ment free chlorine,
ph/T-com-
pensated
Zero-point calibration X X
Slope calibration X X
Two-point calibration X X
Rel. cell constant X
Temperature coefficient X
TC-curve X
Universal input
Operation modes
Calibration
routine