Starting the unit
23
Starting the unit
After all preparations have been completed, you can
begin the cooking process.
1. Make sure that the cooking container is properly
filled and the
Pearl
is correctly installed and con-
nected.
2. Switch on the
Pearl
at the rear of the unit. The
unit will go into Standby and display the OFF
message.
3. Use the arrow keys
to set the target
temperature. Press
to adopt the entered val-
ue as the target temperature.
We recommend starting with a temperature of
62 °C (143.6 °F). The following table provides a
few guidelines.
Temperature guidelines for beef
English
< 58 °C (<136.4 °F)
Medium
58 - 61 °C(136.4 -141.8 °F)
Well done
> 61 °C (<141.8 °F)
4. To start the unit, press and hold the
key for
about 2 seconds. The Pearl will start, i.e. the cir-
culation pump and heater will function to heat the
water bath to the target temperature.
The display will change while the unit is in opera-
tion: The display indicates the temperature cur-
rently measured in the water bath.
To display the target temperature, press one of
the arrow keys
briefly. If no further value
Setting the
desired temp.
Starting the unit
