Julabo DYNEO DD, Оригинальное руководство по эксплуатации

Страница: 89 / 96

Appendix
89
Auxiliary parameters System response
in_hil_00
Set actuating variable limit for cooling capacity (%)
in_hil_01
Set actuating variable limit for heating capacity (%)
11.1.2 OUT commands
OUT commands set device parameters. Remote control mode must be active.
Parameter
settings Parameter Setting
out_sp_00
xxx.xx Setting for the setpoint temperature
out_sp_03
xxx.xx Setting for the high temperature
out_sp_04
xxx.xx Setting for the low temperature
out_sp_06
xxx.xx Setpoint temperature setting via watchdog function
out_sp_07*
x Set pump to preset levels 1…5
out_sp_10
xxx.xx Setting for the actuating variable via the serial
interface
out_sp_11
x Setting the temperature units:
0 = °C
1 = °F
out_sp_27
xxx Pump capacity in %
out_sp_28
xxx.xx High temperature alarm limit setting
out_sp_29
xxx.xx Low temperature alarm limit setting
* Do not use for reprogramming, use out_sp_27 instead. Pump stage 4 has an output pressure of
approx. 450 mbar.
Device modes Parameter Setting
out_mode_01
x Setting 0 (for reasons of downwards compatibility
the parameters 1 or 2 can also be used. Within the
device it has no effect)
out_mode_03
x Setting of the operating mode EPROG:
0 = 0-10 V
1 = 0-20 mA