Julabo BAT7146, Руководство по эксплуатации, Страница: 83 / 172

Shaking Water Baths
81
E
ngl
is
h
12.2. List of commands
Command Parameter Response of the shaking water bath
version none Number of software version(V X.xx)
status none Status message, error message (see below)
out_mode_05 0 STOP - returns the water bath to the „OFF“ state
out_mode_05 1 START - water bath is switched to the operating state
out_mode_08 0 Circulator pump „OFF“
out_mode_08 1 Circulator pump „ON“
out_mode_09 0 Shaking operation drive motor „OFF“
out_mode_09 1 Shaking operation drive motor „ON“
out_sp_00 xxx.x Set working temperature„T“
out_sp_02 xxx.x
Set high temperature warning limit
out_sp_03 xxx.x
Set low temperature warning limit
out_sp_16 xxx.x Set shaking frequency
in_sp_00 none Ask for working temperature „T“
in_sp_02 none
Ask for high temperature warning limit
in_sp_03 none
Ask for low temperature warning limit
in_sp_16 kein Ask for shaking frequency
in_pv_00 none Ask for actual bath temperature
in_pv_01 none Ask for the heater wattage being used