Jula Meec tools 210-255, Руководство по эксплуатации

Страница: 24 / 25

ENGLISH
24
NOTE:

Do not try to control the sanding head.

Check all the connections before starting.

Do not use long handles when working in confined spaces and/or areas where access is difficult.

Use a medium-long handle when working on walls.

Use a long handle when working on ceilings.

Do not press too hard on the tool – risk of overloading. The correct pressure produces better
sanding. Use the correct sanding material for the best results.
MAINTENANCE

Always unplug the power cord before making adjustments and carrying out maintenance.

The tool does not require any special lubrication or maintenance. Store the tool in a dry place.

A damaged power cord must be replaced by an authorised service centre, or qualified person, to
ensure safe use.

Any faults must only be repaired by qualified personnel or an authorised service centre.
Cleaning

Keep the tool's safety devices, ventilation openings and motor casing clean. Clean the tool with a
clean cloth, or with compressed air at low pressure.

Always clean the tool after use.

Clean the tool with a cloth moistened with a mild detergent. Never use strong detergents or
solvents, they could damage the plastic parts on the tool. Never allow water to enter the tool.
Carbon brushes
The carbon brushes must be replaced when they become worn out.
TROUBLESHOOTING
Problem Cause Action
The motor does not start when
the power switch is switched on. Fault in power cord, plug and/or
power outlet. Check and repair the power cord,
plug and/or power outlet.
Fault in the power switch. Replace the power switch.
Tool makes abnormal noise and
the motor does not start, or runs
slowly when the power switch is
switched on. Fault in the power switch
contacts. Have the power switch replaced.
Blocked components. The power tool must be checked
and repaired.
The motor speed drops as a
result of overloading. Reduce the load.
The motor overheats. Foreign object in the motor. Remove foreign object.
Lack of lubricant, or
contaminated lubricant. Add or change lubricant.
Pressure is too high. Reduce the load.
Sparking from the commutator. Short-circuited rotor. Replace rotor.
Worn or blocked carbon brushes. Have the carbon brushes
checked and replaced if
necessary.
Uneven surface on the
commutator. Clean or polish the surface of the
commutator.
Jula reserves the right to make changes. In the event of problems, please contact our service
department.
www.jula.com