JUKI MF-7500-E11, Инструкция по эксплуатации, Страница: 7 / 10

– 5 –
Adjust the distance between the right-hand needle
and cutting position as described below.
1) Loosen setscrew
❶
, turn adjustment screw
❷
,
and laterally adjust moving knife ❸ and fixed
knife
❹
.
❸ and ❹ move to the left when adjustment screw
❷
is turned clockwise, and to the right when it is
turned counterclockwise.
2) After the adjustment, tighten setscrew
❶
.
3) After the adjustment of the knife width, readjust
the spring pressure.
6.ADJUSTMENT PROCEDURE OF KNIFE CUTTING POSITION
❶
❷
❸
❹
1) Loosen setscrew ❷ at the position where moving
knife ❶ is fully lowered and make a state that
moving knife ❶ can be moved up and down.
2) Adjust the engagement amount of moving knife ❶
and fixed knife ❸ to approximately 0.5 mm from
the top end of moving knife, and tighten setscrew
❷
.
7.ADJUSTMENT PROCEDURE OF ENGAGEMENT AMOUNT OF KNIVES
0.5mm
❶
❷
❸
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the follow-
ing work after turning the power off and ascertaining that the motor is at rest.
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the follow-
ing work after turning the power off and ascertaining that the motor is at rest.