– 11 –
8. Adjusting the sensor position
①
Tilt the main body of sewing machine.
②
Place the jig on the top surface of the bed. Adjust the position (temporary positioning) and angle of the
sensor with screws
❶
to
❺
as shown in Fig. 1.
③
Turn ON the power to the sewing machine. Press the ready key (needle bar stop position button
)
on the operation panel of the sewing machine.
The sensor head emits light. Take care not to allow the light to directly enter your eyes.
Fig.1 Sensor position adjustment points
Only as a guide, assemble the jig and the sensor
mounting plate so that they are positioned to have
an equal clearance of 1 mm over the length (in
parallel with each other).
❹
❶
❷
❸
❺
Sensor mounting plate
Jig
WARNING
1. Be sure to turn OFF the power to the sewing machine for the sake of safety before assembling the sen-
sor amplifier components.
2. Be sure to firmly tighten the screws to prevent them from loosening by vibration when the sewing ma-
chine is in operation.
3. Jig is separately available. The gauge set (part number: 40250040) for the SD-29 should be purchased
separately.
4. Be sure to turn OFF the DPC function. (Refer to
.)
WARNING
1. Take care not to allow the direct laser light or the mirrored-surface reflected laser light to enter your
eyes.
2. The laser light irradiated from the laser has a high optical power density and therefore can cause blind-
ness when it enters the eye.
WARNING
Do not disassemble the sensor.
If the sensor is disassembled, the laser light will leak to cause impaired eyesight.