JUKI LU-2860V-7, Инструкция по эксплуатации

Страница: 27 / 172

– 22 –
2-17. Adjustment of the pedal
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of the
sewing machine.
2-18. Pedal operation
The pedal is operated in five steps.
1) The machine runs at low sewing speed when you
lightly depress the front part of the pedal. B
2) The machine runs at high sewing speed when you
further depress the front part of the pedal.
A
(If the
automatic reverse feed stitching has been preset,
the machine runs at high speed after it completes
reverse feed stitching.)
3) The machine stops (with its needle up or down)
when you reset the pedal to its original position. C
❷
❹
❷
❶
❸
A
C
E
D
B
4) Presser lifting operation D is performed by lightly depressing the back part of pedal.
5) Thread trimming operation
E
is performed by further depressing the back part of pedal.
• When starting sewing from the state that the presser foot has been lifted with the Auto-lifter and you
depress the back part of the pedal, the presser foot only comes down.
• If you reset the pedal to its neutral position during the automatic reverse feed stitching at seam start, the
machine stops after it completes the reverse feed stitching.
• The machine will perform normal thread trimming even if you depress the back part of the pedal imme-
diately following high or low speed sewing.
• The machine will completely perform thread trimming even if you reset the pedal to its neutral position
immediately after the machine started thread trimming action.
2-17-1. Installing the connecting rod
1) Move pedal
❸
to the right or left as illustrated by
the arrows so that motor control lever ❶ and con-
necting rod ❷ are straightened.
2-17-2. Adjusting the pedal angle
1) The pedal tilt can be freely adjusted by changing
the length of the connecting rod ❷ .
2) Loosen adjust screw
❹
, and adjust the length of
connecting rod
❷
.