JUKI LU-2860V-7, Инструкция по эксплуатации

Страница: 147 / 172

– 142 –
9-5. Condensation custom pattern
Condensation stitches can be sewn while specifying needle
entry points as desired, by setting a condensation custom.
As many as 20 steps can be created in one pattern. The max-
imum number of patterns that can be registered is nine.
<Figure: Example of the condensation custom pattern>
Step 1
1 mm 3 stitches
Step 2
1.5 mm 4 stitches
Step 3
1 mm 3 stitches
Step 5
1.5 mm 2 stitches
Step 4
‒1 mm 3 stitches
Condensation custom pattern
1. With some combinations of stitch length, direction
of feed and sewing speed, the sewing machine may
fail to finish a sewing pattern exactly according to
the settings.
2. Needle cannot be entered to the same needle entry
point when the stitch length is set to 0.0 mm.
9-5-2. Creating a new condensation custom
① Selecting the condensation custom pattern setting on the mode screen
1) Press ❶ .
The "mode screen" is displayed.
2) Select the "4. Condensation custom sewing
setting".
The "condensation custom pattern list screen"
is displayed.
❶
<Mode screen>
A new condensation custom pattern creation procedure is described as follows using < Figure: Example of
the condensation custom pattern > as an example.
9-5-1. Selecting the condensation custom
Select condensation custom pattern referring to "6-2-3. (2) ◆ In the case of maintenance personnel mode" p.
58 .
The condensation custom pattern for reverse-feed stitching at the end of sewing can be set in the similar
manner.