– 9 –
(2) Lower stop position
) The DOWN needle stop poston when the
pedal s returned to the neutral poston
after the front part of the pedal s depressed
s between the poston where the needle
perces the feed dog and the upper end of
needle eyelet algns the top surface of feed
dog and that where needle snks by 3 mm.
2) The same as UP stop, stop needle
2
n
DOWN poston, turn OFF the power, and
loosen screw
3
to perform adjustment wthn
the slot of the screw. The needle stop tmng
s advanced f you move the screw n the
drecton of
E
, and the tmng s delayed f
you move the screw n the drecton of
F
.
Do not operate the machine with
screw
3
loosened. Just loosen
the screw, and do not remove it.
(1) Stop position after thread trimming
) The standard needle stop poston s obtaned
by algnng marker dot
A
on the pulley cover
wth whte marker dot
B
on the handwheel.
2) Stop the needle n UP poston, turn OFF
the power, and loosen screw
3
to perform
adjustment wthn the slot of the screw. The
needle stop tmng s advanced f you move
the screw n the drecton of
C
.
The needle stop tmng s delayed f you move
the screw n the drecton of
D
.
Do not operate the machine with
screw
1
loosened. Just loosen
the screw, and do not remove it.
4-12. Adjusting the needle stop position
WARNING :
Turn OFF the power before starting the work so as to prevent accidents caused by abrupt start of
the sewing machine.
A
B
C
D
1
Top surface of feed dog
0 to 3 mm
2
3
E
F