JUKI LH-3500 Series, Инструкция по эксплуатации, Страница: 37 / 50

– 35 –
6-9. Position of the wiper
6-10. Caution when installing the attachments
) Adjust engraved marker dot
1
on the machne arm to whte marker dot
2
on the handwheel.
2) Move rod
3
n the drecton of the arrow, and adjust wth two clampng screws
5
so that the
clearance between the top end of needle and wper
4
s approxmately 2 mm.
Be careful that screw
A
does not protrude n the
rear of the bed slide when fixing the attachment to
the bed slde wth the screw.
When it protrudes as shown in the
figure, the screw interferes with other
components and break-down will be
caused.
Needle
2mm
3
5
4
2
A
WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
1