JUKI LBH-1790AN, Инструкция по эксплуатации

Страница: 46 / 88

– 43 –
Data of pattern No. which has been already registered can be copied to pattern No. which has not been
used. Overwriting copy of the pattern is prohibited. When you desire to overwrite, perform it after erasing
the pattern once.
1) Set the mode to input mode.
Under the input mode where SET READY LED
goes out, copy is enabled.
If the current mode is the sewing mode, press
READY key ❷ to change over the mode
to the input mode.
2) Select pattern No. of copy source.
Press ITEM SELECT key ❻ to select the
source pattern No.
→
Refer to "V-5. Performing pattern selection"
p.27
When creating pattern data quite newly. it is
convenient to copy the initial value pattern.
→ Refer to "V-10. Using the initial value pat -
tern" p.33
3) Call copy screen.
Press COPY key , and copy screen A is
displayed.
4) Select pattern No. of copy destination.
Pattern No. B which is not used is displayed.
Press DATA CHANGE key ❼ to select a
number to be used for copying. When you desire
to erase the pattern, select the garbage can .
5) Start copying.
When READY key ❷ is pressed, the copy starts. Then, the screen returns to the input screen on
which the pattern No. which is created by copying is selected.
When RETURN key
❾
is pressed, the screen returns to the previous screen without performing
copying.
* In addition, cycle data and continuous stitching data can be copied by the same method.
Pattern No. (B) of
copy destination
Pattern No. of
copy source
14. Copying sewing pattern
A
❼ ❻ ❾
❷