– 58 –
2-24. using information
There are three functons below n the nformaton functon.
1) Oil replacement (grease-up) time, needle replacement time, cleaning time, etc. can be specified
and the warning notice can be performed after the lapse of the specified time.
Refer to
-2-24.(1) observing the maintenance and inspection information" p.58
2) Speed can be checked at a glance and the target achevng conscousness as a lne or group s
ncreased as well by the functon to dsplay the target output and the actual output.
Refer to
-2-24.(3) observing the production control information" p.60
and
-2-24.(4) Performing setting of the production control information" p.61
3) Informaton on machne workng rato, ptch tme, machne tme and machne speed can be
dsplayed from the workng state of the sewng machne.
-2-24.(5) observing the working measurement information" p.63
Informaton on the followng three tems s dsplayed n the
mantenance and nspecton nformaton screen.
• Needle replacement
:
(1,000 sttches)
• Cleanng tme (hour)
:
• Ol replacement tme (hour)
:
The nterval to nform of the nspecton for each tem n button
C
s dsplayed at
D
, and remanng tme up to the replace-
ment s dsplayed at
E
. In addton, remanng tme up to the
replacement can be cleared.
(1) observing the maintenance and inspection information
1
Display the information screen.
When nformaton key
A
of the swtch seat secton s
pressed n the data nput screen, the nformaton screen s
dsplayed.
2
Display the maintenance and inspection information
screen.
Press mantenance and nspecton nformaton screen dsplay
button
B
n the nformaton screen.
A
B
D
E
C
