JUDO HEIFI-TOP
5
Intended use
2.
Intended use
The installation and operation of the filter is
subject to the following existing national
regulations.
In addition to the operating instructions and
the obliging regulations concerning accident
prevention that exist in the country of opera-
tion and the location of use, the established
technical regulations concerning safe and
professional work, should also be observed.
The filter has been developed and manufac-
tured using state of the art technology and the
established safety regulations in Germany.
The filter may only be operated in accor-
dance with the manufacturer’s specifica-
tions. Any other operation or operation be-
yond the specified use, is not in accordance
with the manufacturer’s specifications.
Additional dangers may result in the event of
the device not being operated in accordance
with the manufacturer’s specifications and
non-observance of the danger symbols or
safety instructions. The manufacturer / sup-
plier cannot be hold liable for any damages
caused by these additional dangers. The
operator is responsible for these risks.
The use of the device in accordance with the
customer’s specifications includes the
observance of the operating instructions.
The manufacturer / supplier should be con-
sulted prior to any operation of the filter
other than in the operational areas stated in
these operating instructions.
The filter may only be operated in a techni-
cally faultless condition, in accordance with
the manufacturer’s specifications and the
stated safety and danger relevant instruc-
tions and under observance of the operating
instructions!
Any functional defects are to be removed
immediately!
2.1
Water pressure
The water pressure must not fall below
15 psi (100 kPa) as otherwise the back-
washing can be impaired! If the filter is not
backwashed regularly a pressure loss can
result and this can impair the filter function.
2.2
Notes on special dangers
2.2.1 Electrical equipment /
installations
Electrical devices/equipment that are not
splash-water proof and are situated in the
direct vicinity of the filter may be damaged
by water leaking from the filter caused as a
result of the device not being operated in
accordance with the manufacturer’s specifi-
cations. In addition this may also result in
short circuits if these electrical devices/
equipment being connected to the electrical
power supply. In the event of such cases
persons are at risk and may sustain elec-
trical shocks. Therefore any electrical
devices/equipment situated in the direct
vicinity should be splash-water proof,
respectively comply with the statutory
requirements for wet areas (IP44).
There must not be any electrical
cables and devices underneath or in
the immediate vicinity of the filter!
