Judo 8204016, Инструкция по установке и эксплуатации

Страница: 30 / 36

30 JUDO i-soft TGA 4
Data sheet
9.3 Installation dimensions
9.4 Scope of supply
– 2 water softening systems
– 2 salt reservoirs
– Rotary flange fitting
JQE 1¼" with screw connection
– JQT parallel quick-assembly kit
– 2 safety overflow hoses
– Water trap with attachment in duplicate
– Bracket set
– Wall support
– Installation and operating instructions
9.5 Accessories
– Hardness measuring instrument
(order no. 8742120)
– JQX bypass valve
(order no. 8735210)
– Connecting cable to ZEWA WATER STOP
(order no. 2201239)
– Leak sensor (order no. 8203554)
– Fault signalling cable
(order no. 2200717)
– Set with 2 connectivity modules
(order no. 8235011)
– Safety module for backup power supply
in case of power loss (order n. 2201871)
9.5.1 Protective measures to pre-
vent corrosion
For water with water hardness 0 °e, plastic
pipes or corrosion-resistant pipes should be
laid.
For water with partial softening (about
10 °e), galvanised pipes and copper pipes
can be laid.
Our recommendation:
Installation of a JUDO JULIA dosing pump in
the mixing water pipe downstream of the
water softening system, so that the water
can be admixed proportionally with a JUL
mineral solution.
The JUL mineral solutions contain sub-
stance components that stabilise the re-
maining carbonate hardening components
and create the conditions for formation of a
homogeneous protective layer in the down-
stream pipe system. These substance com-
ponents correspond in the prescribed type,
quality and quantity to section 11 of the cur-
rent German Drinking Water Act (“Treat-
ment substances and disinfection process-
es”).
Fig. 11: Installation dimensions
A
230 Installation length
B
735 Device width
C
165 Height above the pipe middle
D
465 Height below the pipe middle
E
430 Installation depth up to the pipe
H 240
Maximum gap
between water softening system
and salt reservoir
K 990 Total width of the salt reservoirs
L 475 Depth of the salt reservoirs
M
560 Height of the salt reservoirs
Sewer connection necessary
All dimensions in [mm] (see fig. 11)