OPERATING AND INSTALLATION
– MARCH 2013
WWW.JSI-UK.COM
Page 6 of 9
The connection leads are in accordance with the following codes:
Green/Yellow = Earth
Blue
= Neutral
Brown
= Live
1) Unpack product and check for damages and shortages.
2) Location of product should be between 65 & 75cm from
the hob (see page 4) and (fig.1) however, there is
also a minimum clearance requirement for the hood
’s
internal motor block (fig.2).
3) The distance between the motor block should be a min
of 94cm for gas hobs and a min of 84cm for gas hobs.
In order to set this distance, remove the screws shown
(fig.3) and position the motor block to provide the
Correct clearance when installed.
4) Remove the split extraction plate as shown (fig.2)
5) The distance between the motor-block and the hob
should be 84cm (gas hobs) and 94cm (electric hob). In
order to set these distances, remove the screws as
shown in (fig.3) and slide the motor block within the
body. When the distance has been correctly achieved,
re-fit the screws.
6) Using the template supplied (fig.4)
On the ceiling, drill 10mm holes at position A,B,C & D.
(If ceiling is not strong enough, alternative fixings should
be used instead of plugs).
Screw the 5.5mm 45 YSB screws into the plugs leaving
approximately 5mm for any final adjustment.
Position the hood
so the “keyhole” openings pass over the
screw-heads and then twist clockwise to fix. Tighten screws
to complete. (fig. 4)
7) Fix duct system if applicable testing the connection to ensure
It remains in place at maximum fan speed (fig.5)
8) Pass the chimney section over the suspended motor
block and fix with the supplied fixings.
(fig.6)
9) Place the body on the motor block, pass the hangers through
The plastic headed screws and turn the body clockwise (fig.7)
10) Connect and click together the lamp holder and switch (fig.8)
Changing the 20w halogen lamps
Fig. 3
Fig. 4
Fig. 6
Fig. 2
Fig. 5
Flue
Fig. 7
Fig. 8