PEBBLE UNDERMOUNT SINK MODEL #007-307-XXX
215 North 4
th
Street, Jeannette, PA 15644 ph:724.523.5567 fax:724.523.0123
www.jsgoceana.com
Allow 2” minimum for clearance
around sink rim for clip attachment.
Sink
Countertop
Clip (not included)
Sealant
Foam bumpers (optional)
6”
1 ¾” drain hole
19 ½”
L Bracket
1. Inspect sink prior to installation. No returns accepted after installation unless product is mechanically
defected.
2. Provide your countertop manufacturer with your lavatory template (provided), to assist in your granite
cut-out. Templates are supplied only as a guideline, the physical use of the sink will assure an accurate
cut-out. JSG
Oceana
takes no responsibility for inaccurate cutting of the granite.
3. Pre-install the drain to the lavatory, if possible.
4. Clean the underside of the countertop and the rim of the lavatory.
5. Loosely install the clips (not provided) into your pre-drilled countertop.
6. Apply a clear epoxy/caulking to the top rim of the undermount and then hold it in place under the
countertop.
7. While holding the lavatory in place, rotate & tighten clips evenly.
8. Wipe away excess sealant and allow sealant time to set, according to sealant manufacturer’s instructions.
9. Complete the water supply and drain connections.
10. Run water into the lavatory and check for leaks.
Undermount Installation Instructions:
Product Specifications
Basin Dimensions: 17” W x 14” D
Rim: Flat
Height: 6”
Depth: 5 ½”
Drain hole: 1 ¾”
Centered drain hole
Glass thickness: approx. ½”
Weight: 14 lbs.
Under counter installation
Template provided
Codes/Standards Applicable
Specified model meets or exceeds the following:
IAPMO/UPC & CUPC
IAPMO/CSA
17”
14”
1 1/8”
19 ½”
16 ¼”
Top rim: 1 1/8”
Underneath rim: 7/8”
Template included with sink:
Templates are supplied only as a guideline. The physical use of the sink will assure an accurate cut-out.
Tools and Materials:
Sealant
