JS Automation MPC8024, Руководство пользователя

Страница: 21 / 36

20
8. Hardware settings
8.1 Card ID setting
Since PCIe cards have plug and play function, the card ID is required for programmer to identify
which card he/she will control without knowing the physical address assigned by the Windows. A 4 bits
ROTARY switch (select from 0 to 0xF )for extinguishing the 16 identical card.
8.2 Polarity setting for over-travel limit switch
For different applications maybe you have different considerations, the polarity of over-travel limit
switch can be set by on card Dip switch to meet your requirement.
Default : A, Z, Y, X axis are in negative polarity , the DIP switch set as follows.
Example : A, Z axis are in negative polarity and Y, X axis polarity are positive, the DIP switch set as
follows.
8.3 JP0 Jumper setting
JP0 is used for the EMG input polarity, leave it open, the EMG input is A contact
(normally open, if contact close, emergency occurs). Short the jumper, the EMG input is B contact
(normally close).
Note: The factory default setting is jumper short (input contact NC) .
8.4 JP1 Jumper setting
1-2 short Pull High 2-3 short Pull Low
Jumper JP1 is used for the TTL output default state, if you disable the TTL port or at computer
start-up period, the default state will be output. Select the one to match with the succeeding circuit.