PAGE 13
SCENECONTROL 100 OPERATING INSTRUCTIONS
Design, Manufacture and Installation of Theatrical Equipment Worldwide
(315) 451-3440
Fax (315) 451-1766
www.jrclancy.com
Rev 3: October 7, 2009
, and have a reliable means of communication between the
to the desired position. Once all
ill appear below this button, along with YES
problem, touching the NO button will
he SYS PRST PAGE button is used to return to the system presets page.
Appendix I: Troubleshooting
spotters positioned where they can observe the move
spotters and the operator.
SYSTEM PRESETS RECORD PAGE
utton opens the system presets record page for
Since a system preset will record the current
position of every unit as targets, the operator
should first use each set’s base page to run
the set
From the system presets screen, the PRESET RECORD touchb
the control system.
winches are in position, open the system
presets record page.
To record a preset, first touch the numeric field
to the right of the ENTER PRESET NUMBER
prompt. A numeric keypad will pop up. Key in
a preset number (1-8), and press the ENTER
(<-) key to enter it. Next, touch the field to the
right of the ENTER PRESET COMMENT
prompt. An alpha keyboard will pop up. Use
this keyboard to enter a preset comment (up to
16 characters long), and press the ENTER key
to enter it. Next, touch the selection buttons next to the winch names to select the desired winches for this preset;
these buttons may be toggled on or off with successive presses. Once the winches have been selected, touch
the PRESS TO RECORD button. The prompt “ARE YOU SURE?” w
and NO buttons. Touch the YES button to record the preset. If there is a
top the recording process and allow you to make required changes.
s
T
If
status p
an axis fails to operate, the first step is to check the winch status page for information on that machine. See the
age section of this manual for details.
cument "Troubleshooting Powered Equipment" (JR
lancy manual P359908) provides guidelines for troubleshooting. If trouble cannot be cleared using the steps
s document, contact J.R. Clancy, Inc. directly.
OTHER PROBLEMS:
In case of problems operating the system, the attached do
C
outlined in thi
