JRC JFS-280, Инструкция по эксплуатации

Страница: 82 / 328

3 Operating procedures 3-20
3
Entering values 3.2.4
The menu items in which numbers are entered are highlighted when they are in the number
input mode.
To input numbers, you can use the number keys, arrow keys, or MULTI knob.
The number input mode is indicated by highlighting, as in the following example, which shows
the item name and the item value. The right side of the item value appears white and the inside
the item value and the same value are shown.
The various methods to input numbers can be used to change the numbers.
Number input mode example
Item names Item value
(value before change) Item changed value
(value that you intend to change)
Inputting numbers with the MULTI knob
(1) While a "Menu" is open, turning the [MULTI] knob highlights the selected items. Select
the item you want, and press the [MULTI] knob or press the [ENT] key to activate
number input mode.
(2) Turn the [MULTI] knob to the right to increase the value one step. Turn it to the left to
decrease the value one step.
(3) If the number exceeds the upper or lower limits, a buzzer sounds and the value does
not change. For items with specified input values, if the value is outside the upper or
lower limits, the operation cannot be done. When this happens, a buzzer sounds to
indicate the value is outside the upper or lower limit.
(4) For items in which negative numbers can be input, turn the [MULTI] knob to the left to
reduce the value one step at a time in the negative direction.
(5) To redo a setting, press the [CNCL] key to return to the initial value and the status to
step (1).
(6) When the value reaches the desired value, press the [MULTI] knob or the [ENT] key to
set the value and reflect it.
(7) Turning the [MULTI] knob while inputting values with the number keys does the status
operations (2) to (6) using the values that are currently input.
(8)
Each time a value is changed the screen reflects the change, depending on the
item. However, if you do not do step (6), the values are not set.