JRC Alpatron AlphaMidiCourse, Инструкция по установке и эксплуатации

Страница: 32 / 82

2 True Bearing 2: ***
***.*
ESt or GYt
ESt = External Sensor true bearing
GYt = Gyro-compass true bearing
3 Master Compass Bearing:
***.*
C.P.S
C.P.S. = Compass
4 Latitude: ***.*
***.*
LA.n or LA.S
LA.n = Latitude North
LA.S = Latitude South
5 Ship's speed: ***.*
***.*
G.Sd or H.Sd or L.Sd or S.Sd
G.Sd = Gps.Speed
H.Sd = Hand.Speed
L.Sd = Log.Speed
S.Sd = Serial.Log.Speed
6 Rate of turn: ***.* rt. = Rate of turn
****
rt.
7 Alarm content:
****
Err
Err = Error
Table 7: Data / Mode Menu Structure
2.2.1 Steering Sensor Selection
1. Press the GYRO button to select the Gyro Compass and press ACK/ENT.
2. Press the EXT button to select the External Heading Sensor and press ACK/ENT.
2.2.2 Setting of the Latitude Input
1. Press the SET button.
2. Press
▼or▲
to select either GPS or GYro.
3. Press ACK/ENT to enter selection.
Note When H.Sd (MANUAL) was selected, as the latitude is displayed in the Data Indicator, press
▼or▲
to
set the latitude and press ACK/ENT again. The herein after calculated latitude by the ship's speed and the
True bearing is indicated by using the manually entered latitude.
2.2.3 Setting of the Ship's Speed Input
1. Press the SET button and use
▼or▲
to select one of the following modes: G.Sd (GPS), H.Sd (MANUAL), l.sD (LOG
PULSE), or S.Sd (LOG SERIAL).
2. Press ACK/ENT to enter selection.
32 | Operation