www.jps.com.tw
88
※ 14.1.1.2 Speed Source Select=1【Speed Set from AI-1 (Set Speed= Pr.119 * 0.1rpm)】
【Note】
Depending on the source of the speed command to read Pr.119 (AI1 Analog A / D conversion value),
the value is multiplied by 0.1, as the speed command
。
Pr.132(AI1/AI2 AI1 & AI2 Range Select) suitable:0/1/2/3
【Description】
Assuming Pr.119 = 11200, then the current speed command = 1120.0 rpm
※ 14.1.1.3 Speed Source Select=2【Speed Set from AI-2 (Set Speed= Pr.131 * 0.1rpm)】
【Note】
Depending on the source of the speed command to read Pr.131 (AI2 Analog A / D conversion value),
the value is multiplied by 0.1, as the speed command
。
Pr.132(AI1/AI2 AI1 & AI2 Range Select) suitable:0/1/2/3
【Description】
Assuming Pr.131 = 11200, then the current speed command = 1120.0 rpm
Pr.129(AI2 Drift)
Pr.130(AI2 Gain)
Pr.131(AI2 Result Value)
AI2
Pr.132(AI1/AI2 Input Type)
Pr.249(Dec Ramp)
Pr.248(Acc Ramp)
Pr.250(S-curveT1)
Pr.251(S-curveT2)
Pr.252(S-curveT3)
Pr.253(S-curveT4)
DIx(10):Speed Command SW0
-
DIx(11):Speed Command SW1
DIx(12):Speed Command SW2
I/O first
Pr.260(Speed Set0 (RAM)
Pr.267(Speed Set7 (EAROM)
TO
Pr.255(FWD/REV
Control Type)
Pr.203
(Motor Max Speed)
Pr.002:Speed Source Select
SPEED BLOCK
Pr.117(AI1 Drift)
Pr.118(AI1 Gain)
Pr.119(AI1 Result Value)
AI1
Pr.132(AI1/AI2 Input Type)
Pr.249(Dec Ramp)
Pr.248(Acc Ramp)
Pr.250(S-curveT1)
Pr.251(S-curveT2)
Pr.252(S-curveT3)
Pr.253(S-curveT4)
DIx(10):Speed Command SW0
-
DIx(11):Speed Command SW1
DIx(12):Speed Command SW2
I/O first
Pr.260(Speed Set0 (RAM)
Pr.267(Speed Set7 (EAROM)
TO
Pr.255(FWD/REV
Control Type)
Pr.203
(Motor Max Speed)
Pr.002:Speed Source Select
Speed Cmd
SPEED BLOCK