Doc. No.: 85525 Rev. M
jotron.com
Page 34 of 48
2.
Move the switch from the ready position to the test position and
hold for 15 seconds.
Keep hands and/or other objects away from the
antenna.
3.
Release the switch.
A single flash indicates a passed test. If this is not the
result, refer to the error codes.
Figure 9 Illustration - self-test
9.2.1.1
Error codes (flashes)
If the self-test detects an error in the EPIRB module, one or more of the
following will occur:
Number of
Flashes:
Error codes
2
Low power on 406 MHz transmitter
