jotron 103660, Руководство оператора и инструкция по установке

Страница: 65 / 104

Doc. No.: 103839 Rev. A
jotron.com
Page 65 of 104
10.2 Display settings
10.2.1 Sleeping Targets
The first “Display settings” menu configures
“Sleeping targets”. Sleeping target has a smaller
shape and no vector in order to display a less
cluttered graphic view. Sleeping targets can be
defined to be all vessels outside a defined
range, and/or all class B stations.
10.2.2 Views
Press the View button on the button bar in
order to configure how the ship list and the
graphic view should be displayed.
Here we can configure which columns shall be
shown in “Ships List” (chapter 7.2.6) and if we
want “Head up” or “North up” in “Graphical
view”(chapter 7.2.7).
10.3 Regions
The Regional Settings are primarily used by local base stations to assign special frequencies or transmitter
configurations for certain areas. It is also allowable to add or edit the regions, but this should be done with caution,
as incorrect frequency settings for an area will disable the functionality of the AIS system. Altering the regional
settings is protected by a user password. The Area named HIGH SEA, is the default area and contains the whole
world, except from the other regions, if defined.
Each Region is defined by the following parameters:
Area, defined as North East corner and South West corner
Two channels used for VHF communications
Rx/Tx mode is used to restrict the transmission to one of the two channels.
Output Power is chosen between High or Low setting (1W or 12.5W)
Transitional zone defines the area surrounding an area in order to switch the frequencies in a step by
step order. The transitional zone defined between 1 and 8 NM