Johnson J10RLSUR, Руководство по обслуживанию

Страница: 104 / 229

102
IGNITION
IGNITION COIL
Check for sufficient slack on ignition component
leads. Route component leads through wire
clamps.
Position Coil Locating Ring, P/N 334994, over
machined bosses on the ignition plate. Push the
locating ring in toward the component to be
installed. Hold the ring in place and pull the com-
ponent out toward the ring. Tighten screws to 15
to 22 in. lbs. (1.6 to 2.4 N·m). Do this step for each
component installed.
IGNITION COIL
Removal
Twist and remove cover. Remove the spark plug
and primary leads from the ignition coils.
IMPORTANT:
Make a note of the fastener and
washer locations before removing any screws.
Remove the screws, coil, and washers.
Installation
Assemble the correct sequence of washers and
locate the ignition coil on the powerhead. Install
screws and torque to 48 to 96 in. lbs. (5.4 to 10.8
N·m).
Apply a light coating of Electrical Grease to the
ribbed portion of the spark plug ceramics and to
the openings of each of the spark plug lead cov-
ers. Install the spark plug leads.
Apply a light coating of Electrical Grease to the
opening of each primary lead cover and install the
covers. Observe proper wire routing and ignition
timing. Orange/blue primary lead must be con-
nected to the number 1 ignition coil.
32287
9.9/15 Model
1. Fiber washer
2. Ignition coil ground strap
3. Starwasher
4. Stop switch ground lead
DR5055
3
2
1
2
3
4
2