Johnson Controls Tyco KT-1, Руководство по установке, Страница: 52 / 56

Note: The location defines the controller's time zone. If you enter an incorrect location, it
affects all controllers associated with it.
7. Click Save .
8. Click the Devices tab. If the controller saves successfully, it appears in the list of devices.
Replacing or discarding components
Important:
Only qualified service technicians should perform maintenance
recommendations.
The KT-1 includes a lithium CR2032 primary battery. To avoid risk of explosion, the battery must
be replaced only by a qualified service technician. Do not crush, puncture, open, disassemble or
otherwise mechanically interfere with the battery. Do not try to recharge the battery. If you need
to dispose of the PCB and/or the lithium battery, wrap the KT-1 in non-conductive tape. Check with
your local authorities for battery disposal regulations.
WARNING:
Do not store the batteries in such a way that they come into contact with each
other or with any piece of metal. Explosion or fire may occur. Should fire occur, use only dry
chemical fire extinguishers. Do not use water to put out the fire. Do not heat the batteries.
Do not dispose of the batteries or PCB in a fire. Do not disassemble the batteries. Do not
apply pressure to deform the batteries. Ensure that the above precautions are strictly
observed by related departments, including, but not limited to, production, sales and outside
contractors.
WARNING: There is a risk of fire, explosion, and burns. Do not recharge, disassemble, heat
above 100°C, or incinerate.
KT-1 models, expansion kits, and components
The following table lists of the different KT-1 models, expansion kits, and other related components.
Table 12: KT-1 models, expansion kits, and related items
Product Description
KT-1 One-door IP controller, single gang mount.
KT-1-M One-door IP controller PCB with metal cabinet (No P/S, No BAT).
KT-1-PCB One-door IP Controller PCB including connector board (Compatible with KT-1-
CAB-M or P).
KT-1-CVR Black replacement cover for KT-1 including the back box.
KT-1-CAB-M Metal enclosure only for KT-1-PCB.
KT-MOD-IO16 RS-485 Input/Output Module compatible with the KT-1.
KT-1-PCB-BP Backplate only for KT-1-PCB. KT-1 not included.
USB-485 USB-485 interface, USB cable 3 ft (0.9 m) and USB drivers on CD-ROM.
VC-485 VC-485 interface, RS-232 cable 10 ft (3 m) with RJ-12 connectors, 740-1012 (DB25F
to RJ-12) adaptor, 740-1022 (DB9F to RJ-12) adaptor and 740-1033 (DB25M to
RJ-12) adaptor.
Compliance specifications
UL
When a KT-1 is enclosed in the metal cabinet model KT-1-CAB and powered by the power supply
model KTPS4085 in conjunction with the external adapter PTC1640UG the following performance
levels are defined for the access control unit as per UL 294:
Destructive attack: Level I (no attack test)
Line Security: Level II (Standard line security, RS-485 or Ethernet) and Level III (encrypted line
security 128 bit, Ethernet only)
Note: Line Security Level III requires that you create a trigger and alarm sound in Entrapass.
To create a trigger and alarm sound, complete the steps in the following task:
50
KT-1 One-Door Controller Installation Guide