Johnson Controls tyco iSTAR Ultra, Руководство по установке и настройке

Страница: 23 / 118

Main Features
iSTAR Ultra Installation and Configuration Guide 1–9

1 USB 2.0 Port for communication to the GCM.
I/O (per GCM)

RS-485 Comm Ports
• 2 four-pin Ports for Aperio Hubs

USB 2.0 Ports
• 4 USB host port.
• The only use of USB in the first version is to connect to the ACMs and to import
encryption keys.
• 1 USB Micro B port. (not currently used).
Communications

Two 1 Gbps full duplex, Auto Sense Ethernet Ports.

FIPS-197 and AES 256-bit encryption.

Can cluster with other iSTAR Ultras either encrypted or non-encrypted.

Can cluster with iSTAR Edge, iSTAR eX, iSTAR Pro, iSTAR Ultra SE (Ultra Mode) and
other iSTAR Ultras, when encrypted.
FAI
Fire Alarm Interlock. When the F (Fire) input is true, FAI activates relays that are enabled for
FAI by individual enable switches. The Primary relays (large, mounted in sockets) can be
configured to activate when the FAI signal goes true.
Onboard Controls

LCD with back light for Status and Diagnostics.

Rotary switch for diagnostics.

LEDs for serial, Ethernet, power and relay states.
• Two power LEDs: one super bright
LED that is on when the enclosure door is closed,
and one green LED that is always on when main power is present.
• Relay activation LEDs are not affected by enclosure door.
• All other LEDs only turn on when enclosure door is open.

Soft Reboot button. (Also backs up the DB).

Hard Reset (Stops Linux. Can be used to restore Factory defaults) See Table 4-1 on
page 4-4 .

Switches for serial termination of RM ports.

Switches for selection of relays for control by FAI.

Switches for LED/beep control for Wiegand Ports.