Accessing the connector pins
A.
Remove the two screws located on the top cover (1) (Figure 4) to open it.
Figure 4
Security
Quick Start Guide
(8200-1456-10_E0)
Illustra Flex Gen 2 PTZ Cameras
In the box
1 x Network PTZ Camera
1 x Printed Quick Start Guide
1 x Printed Regulatory document
1 x NTSC/PAL output female BNC cable
1 x 2 position 3mm euro style plug
1 x Torx 20 Security L-Key
1 x Torx 6 Security L-Key
1 x Torx 10 Security L-Key
1 x 12-pin terminal connector for I/O function
1 x Safety cable (Pre-attached to the camera)
Installation tools
1 x Drill
1 x Screw drivers
1 x Wire cutters
Quick reference
Default IP: 192.168.1.168 (DHCP enabled)
Default Username and Password: admin
Note:
For PTZ units that include a bubble ensure that all bubble packaging is
removed before powering up the unit. Also, remove the additional packaging inside
the bubble cap.
Pictorial Index of the camera (IFS02P6INWIT / IFS02P6ONWITA)
Figure 1
Table 1: Pictorial index descriptions
Button / connections
Description
1
NPT Pendant Cap
2
Screws (x2) to open and lock the top cover
3
Top cover
4
Camera lens
5
Camera head
Removing the bubble from the camera (IFS02P6ISWTT)
Note:
This is only applicable to specific indoor units with bubble.
A. Remove the three screws located on the camera head (1) (Figure 2).
Figure 2
Removing the bubble from the camera (IFS02P6ISWTT) (continued)
B. Carefully remove the bubble unit (1) (Figure 3)
Figure 3
Figure 3: Location and descriptions of the buttons / connections
Figure 5
