Enrolling The HSM2HOST
The enrollment of a HSM2HOST to an alarm panel is dependent on the system configuration.
Enrolling the HSM2HOST without a hardwired keypad
To enroll the HSM2HOST without a hardwired keypad, complete the following steps:
1.
Turn on the wireless keypad by connecting the power source.
2.
Simultaneously press [*] and [1] on the keypad.
Note:
The system can take up to 30 seconds to complete the enrollment
Enrolling the HSM2HOST with an enrolled hardwired keypad
To enroll the HSM2HOST with an enrolled hardwired keypad, complete the following steps:
1.
On the enrolled keypad, enter Installer Programming section [902][000] (Auto Enroll All
Modules).
2.
When the system prompts you, press [*].
Enrolling the HSM2HOST with only unenrolled hardwired keypads
To enroll the HSM2HOST with only unenrolled hardwired keypad(s), complete the following steps:
1.
Enroll only one hardwired keypad onto the system by pressing any key on the keypad.
2.
Enter Installer Programming section [902][000](Auto Enroll All Modules).
3.
When the system prompts you, press [*] to enroll the HSM2HOST and all other keypads or
modules on the system.
Enrolling wireless devices
To enroll wireless devices, complete the following steps:
1.
Enroll all the wireless devices intended to be used in the system. For more information, see
the
Wireless device setup and programming
section in this manual, in conjuction
with the manual for each wireless device.
2.
Temporarily place the wireless devices in their locations of intended use.
Note:
You
must
enroll
the
HSM2HOST
to
the
alarm
panel
before
you
can
enroll
the
wireless
devices.
Testing
the
wireless
device
placement
To
test
the
wireless
device
placement,
complete
the
following
steps:
1.
Perform a placement test for each wireless device. For more information, see the
Place-
ment testing wireless devices
section in this manual. Depending on the results of the
placement test, see the following options:
l
If all the results pass the placement test, proceed to the
Permanently mounting
the HSM2HOST
section of this manual.
l
If all results do not pass the placement test:, move the HSM2HOST to a different loc-
ation, or move the devices that failed the placement test to a different location until all
devices pass the placement test.
- 8 -
