NCB-EL Routers
Network Hub use with the NCB-EL Router
44
IFI Routers/Repeaters Installation & Operation Manual - P/N: 53388:Rev: A1 5/5/09
5.4 Network Hub use with the NCB-EL Router
A multi-port network hub (UL 864 Listed) that connects multiple devices to an Ethernet network
can be used with this router. In your routing make sure to do the following:
Step 1. Make sure all power is disconnected and verify the ground connection on the PNET-1 was
made.
Step 2. Connect the router’s 10BaseT connector to a PNET-1’s IN (square end).
Step 3. Connect the PNET-1’s OUT connector (round end) to one of the hub’s PNET-1 OUT
connector.
Figure 5.8 Network Hub Connection Diagram
5.5 NCB Router TCP/IP Configuration Using Ether/Plug
Once the hardware is installed and all wiring connections made, this router must then be configured
for communication over the TCP/IP and Echelon networks. Refer to
for information.
NOTE:
Power-limited and non-power-limited circuits must remain separated in the cabinet
.
All
power-limited wiring must remain at least 0.25 inches from any non-power-limited circuit wiring
.
Run
all non-power-limited wiring along bottom of cabinet
.
All power-limited and non-power-limited circuit
wiring must enter and exit the cabinet through different knockouts and/or conduits.
