Johnson Controls FAC3611, Руководство по установке

Страница: 2 / 22

Installation
Observe the following guidelines when installing a field
controller:
• To minimize vibration and shock damage, transport the
controller in the original container.
• Verify that all parts shipped with the controller.
• Do not drop the controller or subject it to physical
shock.
Parts included
• One field Controller. (Power and SA bus terminal blocks
are removable)
• One installation instructions sheet.
Materials and special tools needed
• Three fasteners appropriate for the mounting surface
(M4 screws or #8 screws)
• One 23 cm (9.125 in.) or longer piece of 35 mm DIN rail
and appropriate hardware for DIN rail mount (only)
• Small straight-blade screwdriver for securing wires in
the terminal blocks
FAC3611 physical features
Figure 1: FAC3611 Physical Features
Table 1: Physical features
Physical feature: description and references
1
Analog Output (AO) Terminal Block: Can be defined as
Voltage Analog Output (0–10 VDC) or Current Analog
Output (4–20 mA) (see Table 2)
2
Device Address DIP Switch Block (see Setting the Device
Addresses )
3
Binary Outputs (BO) Terminal Block: 24 VAC Triac (see
Table 2)
4
24 VAC, Class 2/SELV Supply Power Terminal Block (see
Supply power terminal block )
5 Cover Lift Tab (One of Two)
6 FC Bus Terminal Block (see FC bus terminal block )
7 SA Bus Terminal Block (see SA bus terminal block )
8
Sensor Port: (SA Bus) RJ-12 6-Pin Modular Jack (see SA Bus
port )
9
Binary Input (BI) Terminal Block: Dry Contact Maintained
or Pulse Counter/Accumulator Mode (see Terminal wiring
guidelines, functions, ratings, and requirements
Table 1: Physical features
Physical feature: description and references
10
Universal Inputs (UI) Terminal Block: Can be defined as
Voltage Analog Input (0–10 VDC), Current Analog Input
(4–20 mA), Resistive Analog Inputs (0–600k ohms), or
Dry Contact Binary Input (see Input and Output wiring
guidelines )
11
End-of-Line (EOL) Switch (see Setting the End-of-Line
(EOL) switch )
12 LED Status Indicators (see Table )
13 FC Bus Port (RJ-12 6-pin Modular Jack)
Mounting
Observe the following guidelines when mounting a field
controller:
• Ensure the mounting surface can support the
controller, DIN rail, and any user-supplied enclosure.
• Mount the controller horizontally on 35 mm DIN rail
whenever possible.
FAC3611 Advanced Application Controller Installation Guide 2