Johnson & Johnson Surgical Vision Veritas, Руководство оператора

Страница: 88 / 270

Foot Pedal Setup Z370584 Rev. D
5-8
Surgeon Settings
Table 5.1 – Single Linear Foot Pedal Default Settings
*Table 5.3 – Single Linear Foot Pedal Switch Assignments
Vitrectomy Foot Pedal Modes
Table 5.2 – Vitrectomy Single Linear Foot Pedal Modes
Single Linear Foot Pedal Connections
Attach the foot pedal cable to the connector on the left side of the foot pedal and attach the
other end of the cable to the foot pedal connector on the rear panel of the system (see
Figure
3-2 and Figure 4-2 ).
Single Linear Foot Pedal Switch Assignment
The Single Linear foot pedal has four switches that you can assign specific functions for each
surgeon. For Phaco and Vitrectomy foot pedal settings the switches are set per submode.
Follow the steps below to assign functions to the foot pedal switches.
NOTE: In addition to showing the type and status of the foot pedal, the foot pedal icon in the
top panel (shown below) also allows access to the Foot Pedal Settings screen.
1. On the Surgeons and Programs screen, select a surgeon.
2. Tap .
Parameter Available Settings Default Settings
Pitch regions 1–100% P1=5%
P2=30%
P3=60%
Switch position Switch1= *
Switch 2= * Switch1=Off
Switch 2=Off
Right= *
Left= * Right=Reflux
Left=Off
Feedback On, Off Off
Foot Pedal
Positions
Vitrectomy Foot Pedal Modes
ICA IAC Side VIT
1 Irrigation Irrigation Irrigation
2 Irrigation/Cut Irrigation/Aspiration Irrigation/Aspiration
3 Irrigation/Cut/Aspiration Irrigation/Aspiration/Cut Irrigation/Aspiration