SEEDLING CART
ASSEMBLY INSTRUCTIONS
CODE
STAND PARTS
GA3
GA4
R
Slide rod
2
2
TB
Top bracket
1
1
E
End frame
2
2
P
Plant tray
12
16
SS
Short spacer
2
2
T
Tee
12
16
L
Long piece
2
4
PF
Platform
2
2
BAG KIT
WI
Wheel & insert
4
4
S
Screw
16
20
N
Nut
10
14
DW
Domed washer
2
2
GC
Ground cord
1
1
C
Screw cover
2
2
NOTE:
Take long pieces
L
and place tees
T
on the ends and align the holes. Put a screw
S
through the holes
and start a nut
N
on the screw
S.
This will be the
middle shelf/shelves
.
1
. Place a tee
T
on the end of a platform
PF
and align the holes. Put a screw
S
through the holes, and start a
nut
N
on the screw
S
. Repeat on other three ends. This will be the
top shelf
.
2.
For the
bottom shelf
, place a tee
T
on the end of the remaining platform
PF
and align the holes. Put a
screw
S
through the holes and start screw into the threads in the short spacer
SS
. The short spacer
SS
should be a tight fit between the platform
PF
ends, and the indented hole should be on the outside.
Continue on the other three ends.
3
. Place the wheel inserts into the bottom of the endframes
E
. The endframe ends should be distorted, tapping
may be necessary.
4
. Place the end frame
E
(with the indented hole on the
INSIDE
) through the tees
T
of the top shelf, then the
middle, and finally the bottom shelf. Repeat with other end frame
E
5
. Position the top shelf as desired and tighten the screws
S
, (use a large flat head screwdriver). Place the
remaining shelves where desired and tighten the screws
S
.
6
. Insert a screw
S
into the top hole of the end frame
E
. With the head of the screw on the outside, hang slide
rod
R
over the screw (on the
INSIDE
of the stand). Thread the screw into the top bracket.
7
. Position the bottom of the slide rod
R
on the outside of the short spacer
SS
. Place a screw
S
through the
hole on the short spacer
SS
(with the head of the screw on the
INSIDE
) and between the slide rod
R
ends.
Put a domed washer
DW
on the screw
S
with the indented side towards the slide rod
R
ends. Install and
tighten a nut
N
. Place a screw cover
C
on the end of the screw
S
. Repeat on the other end.
8.
Insert the wheels firmly until locked in place. Place the plant trays
P
on the shelves. Level the shelves by
loosening the screws and adjusting the tees
T
.
