John Lewis JLTDH21, Руководство пользователя

Страница: 21 / 36

Hints and tips
Ecological hints
• Spin the laundry well before drying.
• Do not exceed the load sizes which are
specified in the programme chart.
• Clean the filter after each drying cycle.
• Do not use fabric softener to wash and then
dry. In the tumble dryer laundry becomes soft
automatically.
• Use distilled water like that used for steam
ironing. If it is necessary, clean the distilled
water before (e.g. with a coffee filter) to
remove any particles.
• Always keep the airflow slots at the bottom of
the appliance clear.
• Make sure there is good airflow where the
appliance is to be installed.
Adjustment of dryness levels
To change the default dryness level:
1. Turn the appliance on.
2. Wait approximately 8 seconds.
3. Select 1 of the available programmes.
4. Push and hold down the Dry plus and Anti-
crease buttons at the same time.
One of the symbols appears on the display:
- Maximum dryness
- Extra dryness
- Standard dryness
5. Push the Start/Pause button repeatedly until
you reach the desired dryness level.
6. To set the new dryness level as the default,
push the Dry plus and Anti-crease buttons
for approximately 2 seconds at the same time.
Deactivating the tank
indicator
The water container indicator is activated by
default. It illuminates at the end of the drying cycle
or during the cycle if the water reservoir is full. If
the draining kit is installed the water container is
drained automatically and the indicator can be
deactivated.
To deactivate the indicator:
1. Turn the appliance on.
2. Wait approximately 8 seconds.
3. Select 1 of the available programmes.
4. Push and hold down the Dry Plus and Alarm
buttons at the same time.
One of 2 configurations is possible:
• the Tank indicator: is on if the symbol
appears - the water container
indicator is permanently activated
• the Tank indicator: is off if the symbol
appears - the water container
indicator is permanently deactivated
Tumble Dryer User Manual 21