Problem and alarm code
Possible cause and solution
The appliance stops and starts
more times during operation.
• It is normal. It provides optimal cleaning results and energy savings.
The programme lasts too long.
• If the delayed start option is set, cancel the delay setting or wait for
the end of the countdown.
The remaining time in the display
increases and skips nearly to the
end of programme time.
• This is not a defect. The appliance is working correctly.
Small leak from the appliance door. • The appliance is not levelled. Loosen or tighten the adjustable feet (if
applicable).
• The appliance door is not centred on the tub. Adjust the rear foot (if
applicable).
The appliance door is difficult to
close.
• The appliance is not levelled. Loosen or tighten the adjustable feet (if
applicable).
• Parts of the tableware are protruding from the baskets.
Rattling/knocking sounds from in-
side the appliance.
• The tableware is not properly arranged in the baskets. Refer to
"Loading cutlery and dishes"
.
• Make sure that the spray arms can rotate freely.
The appliance trips the circuit-beak-
er.
• The amperage is insufficient to supply simultaneously all the appliances
in use. Check the socket amperage and the capacity of the meter or
turn off one of the appliances in use.
• Internal electrical fault of the appliance. Contact an Authorised Service
Centre.
Refer to
"Before first use"
,
"Daily use"
, or
"Hints and
tips"
for other possible causes.
Once you have checked the appliance,
deactivate and activate the appliance. If the
problem occurs again, contact an Authorised
Service Centre.
For alarm codes not described in the table,
contact an Authorised Service Centre.
The washing and drying results are not satisfactory
The washing and drying results are not satisfactory
Poor washing results.
• Refer to
"Daily use"
,
"Hints and tips"
and
"Loading cutlery
and dishes"
.
• Use more intensive washing programmes.
• Clean spray arm jets and filter. Refer to
"Care and Cleaning"
.
Dishwasher User Manual
28
