5. Insert each wire into the appropriate hole and
snap down the locking tabs.
See Figure 2
6. Insert the smooth side of the connector plug into
the smooth side of the IR-WMR socket.
7. Install the IR-WMR into
the device ring.
8. Attach the cover plate.
See installation diagram.
Installation Note
The talkback LED can be disabled if it continues to
flicker or visual feedback is not desired. Discrete on
and off IR commands are available on the JobSite
Technical support website for disabling the talkback
LED. The address is:
www.jobsitesystems.com/techsupport/
4
Stereo Receiver
12V DC Power Supply
(Not Supplied) plugged into
the Switched Outlet
12V DC Power Supply
Plugged into an
Unswitched AC Outlet
IR-CB2
JobSite
IR-E1
Emitter
IR-WMR
INSTALLATION DIAGRAM
Figure 2
