3
PACKAGE CONTENTS
n
IR-WMR Receiver x 1
n
Decora
®
style Insert x 1
n
Decora
®
style faceplate x 1
n
Snap and lock Connector x 1
n
Device Mounting Screws x 2
n
Faceplate Screws x 2
PREPARING FOR INSTALLATION
If you are installing the IR-WMR into an existing wall,
take time to consider any possible obstructions
which may be hidden inside the wall, such as wood
or metal studs, electrical, telephone or other types of
wiring, plumbing, AC or heating conduit. You should
avoid locating the IR-WMR near potential sources of
electrical or optical noise, such as light dimmers or
low-voltage lights.
Tools Required
n
1/8" Slotted screwdriver
n
1/4" Slotted screwdriver
n
No.2 Phillips screwdriver
n
Wire stripper
n
Wire labels
INSTALLATION
1. Identify the IR Receiver wire. Label the wire for
future reference.
2. Strip 2" of outer jacket off the end of the CAT5, then
1/4" of insulation from each strand of wire to be used.
3. Locate the Snap and lock connector and remove it
if it is plugged in.
4. Use a small flathead screwdriver or your thumb
to raise the locking tabs, exposing the holes on
the connector.
