FOR NON-MEDICAL PERIODIC CHECK OF BLOOD OXYGEN
SATURATION LEVELAND PULSE RATE AT HOME, AND FOR SPORT
AND RECREATIONAL USES SUCH AS MOUNTAIN CLIMBING, HIGH
ALTITUDE ACTIVITIES AND RUNNING.
THIS FINGERTIP OXYGEN METER IS NOT INTENDED FOR MEDICAL
DIAGNOSTIC OR TREATMENT USE.
1.
Do not use if in cardiac arrest or in shock.
2.
The Oxygen Meter has no alarms and is not intended for continuous
monitoring.
3.
SpO
2
measurements may be adversely affected in the presence of
strong light. Shield the sensor area with a cloth if necessary.
4.
Fingernail polish or false fingernails may cause inaccurate SpO
2
readings.
5.
Inaccurate measurements may be caused by immersing the sensors
in liquid.
6.
Excessive movement may cause inaccurate readings.
7.
Keep away from small children as this device has small parts that
may pose as a choking hazard.
Follow local ordinances for disposal and recycling of the device,
components and batteries.
1.
Fingertip Oxygen Meter is a portable non-invasive, spot-check for
blood oxygen saturation (SpO
2
) and pulse rate.
2.
The Oxygen Meter requires no routine calibration other than
replacement of batteries.
3.
Operation of the product is simple and convenient.
4.
The product is small in volume, light in weight and convenient to
carry.
5.
Power consumption of the product is low and two AAA batteries is
enough for it to operate continuously for 24 hours.
6.
A low voltage warning will be indicated on the LCD display when
battery power is low, replace batteries immediately to avoid
inaccurate measurements.
7.
The product will automatically be powered off when no finger is
inserted into the product within 8 seconds.
Battery
1.
Slide the battery cover and remove.
2.
Insert two AAA batteries with correctly aligned polarities.
3.
Replace the battery cover.
Battery polarities should be correctly aligned. Otherwise, you
may damage the device.
Please remove the batteries if the Oxygen Meter will not be
used for a long time.
Lanyard
1.
Thread the thin end of the lanyard through the loop at the top of the
Oxygen Meter.
2.
Thread the thick end of the lanyard through the thin end, and then
tighten to secure.
1.
Clamp one finger fully into the rubber hole of the Oxygen Meter with
nail facing upwards.
2.
Press the power switch on the front panel to start measurement.
4.
Sit down and relax your whole body while the measurement is being
taken.
5.
Read corresponding data on the display screen.
The pulse rate bar graph displays your pulse beat. The height of the bar
graph shows the strength of your pulse.
When your finger is inserted into the Oxygen Meter, your nail must be
facing upwards.
1.
Replace the batteries immediately when the low voltage warning
lights up.
2.
Clean the surface and the medical rubber of the Oxygen Meter
before usage.
3.
Remove the batteries inside the battery compartment if the Oxygen
Meter will not be operated for a long time.
4.
It is best to store the product in a place where temperature is
between -20°C ~ 60°C (-4°F ~ 140°F).
5.
It is recommended that the product should be kept in a dry
environment at all times. A damp environment may decrease its
durability or even may damage the product.
1.
Lanyard
2.
2 x AAA Batteries (not included)
3.
Instruction Sheet
Power Switch
Pulse Rate Bargraph
Pulse Rate
Oxygen Saturation Level
Cautions
Intended Use
Installation
JB# 5892
Maintenance & Storage
Instructions
Product Accessories
Properties
OXYGEN METER
Instruction Sheet
Item#HSN7239
Installation- (Cont.)
