Joab EcoDrive, Руководство по эксплуатации и обслуживанию

Страница: 31 / 73

Electronic Speed Control- ESC
Speed adjusted movement sequences of the hook lift in the outer operation areas.
EcoDrive Tipper Mode ETM
ETM allows the operator to lower the body automatically, when in tipping mode. When activ-
ated, the body will lower itself using its own weight, the operator does not need to operate the
control-stick. The body is lowered at a controlled and safe speed.
The operator must be fully aware of the environment and area around the vehicle
before operating this function. Failure to do so can lead to serious injury or damage.
The only way to stop this function, is to activate the emergency stop button.
To activate this function, simply press and hold the top button (the button without a small raised
dot on it) on the control-stick while pushing the control-stick fully forward for two seconds, until
the icon
for the lowered status begins to blink – ETM is then activated and the body will lower
itself. See also "Control Stick Function", on page 16 .
Fast Lowering System - FLS
This function is used in shunting mode with an empty body. Fast lowering with intelligent speed
compensation allows the driver to lower an empty body quickly.
Do not use this function with a loaded body. Damage to the hook-lift can occur if this
function is used with a loaded body .
To activate this function, simply press and hold down the bottom button (the button with a small
raised dot on it) on the control-stick when lowering the body. See also
"Control Stick Function",
on page 16 .
Friction Free Drive - FFD
Automatic frictionless operation of the body. Built-in rollers in the auxiliary-lifting-arms (see
"Hook-lift Components", on page 3 ) are assisted by a drive. FFD assists the loading and unload-
ing of a body and allows it to roll smoothly both forwards and backwards. This reduces the stress
placed on the hook-lift.
This function is active by default, however, it can be disabled if required. To deactivate FFD,
simply press the FFD icon
.
The FFD function must be activate when loading or unloading a body that has dowel
pins. These are used to anchor the body onto the vehicle, such as a crane lift body. If
FFD is deactivated, damage will occur when loading or unloading a body with dowel
pins. Make sure that FFD is active.
23
Operation | EcoDrive Standard Functions
EcoDrive manual: 13300 Edition 1 | 2019-01-31