Joab EcoDrive, Руководство по эксплуатации и обслуживанию

Страница: 23 / 73

2. Select the desired page set-up from those displayed and then press the OK button to either
activate it or de-activate it (active page set-ups have a green rectangle below them).
3. Press and hold down the OK button for a few second to save the new settings.
Hook Positioning
The hook position page option displays the pos-
ition of the hook. As shown opposite, the pos-
ition of the hook and its angle are displayed in
the user interface whenever this menu page is
selected (see also
"Page Set-Ups", on page
14 ). This option is only available for L26 hook-lift
models and is dependent upon which optional
sensors have been installed. For further inform-
ation contact JOAB.
NOTE: This function is dependent on the hook-
lift's sensors. If the sensors malfunction or they
are incorrectly positioned, the information dis-
played in the user interface will be incorrect.
The actual information provided should be seen
as an approximation and not an exact value.
Function Buttons
Each of the five page set-ups in the user interface can be configured with six personal functions.
The icons for the selected functions are placed at the bottom of the user interface (shown in
white rectangles, see
"User Interface", on page 12 ). These functions are activated by pressing
the corresponding function buttons below the screen: F1–F4 and the UP/DOWN arrow but-
tons.
To set the desired function associated with the function buttons, follow the procedure below:
1. Press and hold the OK button while simultaneously pressing the function button that is to be
changed.
2. The current icon set for that function will be displayed with a green rectangle
around it, as shown below.
3. Use the UP/DOWN arrow buttons to select the desired function.
4. Press the OK button.
15
Operation | CBW controller
EcoDrive manual: 13300 Edition 1 | 2019-01-31