SECTION 4 - MACHINE OPERATION
3121773
– JLG Lift –
4-9
Jib Position for Travelling
It is necessary to raise the JIB arm when driving up or down
slopes that exceed 10° and but less than the max. 25° to pre-
vent the jib from contacting the ground.
ONLY PERFORM THIS OPERATION WHEN IT IS NECESSARY. IN ALL OTHER SIT-
UATIONS, DRIVE WITH THE BOOM AND JIB FULLY LOWERED AND ALIGNED.
IN SOME CASES AND FOR SOME MACHINE MODELS TO BE ABLE TO RAISE THE
JIB, IN ADDITION TO THE ABOVE CONDITIONS IT IS NECESSARY TO REMOVE
THE PLATFORM.
The permission to use the JIB is indicated
by the icon in position 5 on the remote
control display panel.
Before lifting the jib arm in the traversing
phase, the following conditions must be
verified:
•
All outriggers must be lifted from the ground
•
The platform must be removed from the jib arm.
•
The platform/remote control box must be removed
from the platform and used from the ground.
NOTE:
The aerial part safety device by-pass key must not
have been activated after the machine has been
closed and aligned.
If any of these conditions have not been met, the use of the
JIB is not possible and one of the following error displays
appears.
After these conditions have been met, make sure that there
are no obstacles in the Jib working area and operate as fol-
lows:
•
Activate joystick for moving the JIB arm. If a different
joystick is activated an error message will appear on the
display.
To
order
go
to
Discount-Equipment.com
