SECTION 4 - MACHINE OPERATION
4-24
– JLG Lift –
3121773
The battery cold/heater activated icon will be
shown on the display when the heaters are
enabled. The machine can only be moved in
the lower speed while the heater system is
active.
Cooling Fans
In hot environmental temperatures, the cooling fans sys-
tems becomes active to cool down the battery cells. This sys-
tem is automatically activated by the BMS when cell
temperature raises over 98.6
°
F (37
°
C). The cooling fans sys-
tem will automatically shut off when cell temperature cools
down to 95
°
F (35
°
C).
4.10 SHUT DOWN AND PARK
WHEN PARKING THE MACHINE ON A SLOPE OR UNEVEN GROUND WITH THE
OUTRIGGERS RETRACTED, PARK WITH THE TRACKS IN THE FULLY WIDENED
POSITION AND BLOCK THE TRACKS USING WEDGES TO PREVENT MACHINE
MOVEMENTS.
1.
Drive machine to a reasonably well protected area.
2.
Ensure boom and jib are in the stowed (aligned)
position.
3.
Remove all load and allow engine to operate 3-5
minutes at LOW setting to permit reduction of
internal engine temperatures.
4.
Shut down gas/diesel/electric engine with the
same button on the platform/remote control sta-
tion used to start it. Complete machine shut down
takes approximately 1 minute, LCD display OFF.
5.
At ground and platform controls, push-in emer-
gency stop buttons and remove key at the ground
controls. Turn off engine and remove the key.
6.
Close platform control console lid if necessary to
protect instruction placards, warning decals and
operating controls from hostile environment,
place a cover over this area.
7.
If machine is to be shut down for long periods of
time, turn battery disconnect switch, RED handle
located on the front of the hydraulic tank/battery
tray housing, to the POWER OFF position.
(see
photo below)
To
order
go
to
Discount-Equipment.com
