JLG 680S, Руководство по обслуживанию и ремонту, Страница: 330 / 530

SECTION 4 - BOOM & PLATFORM
4-66 3121234
Installation and Bleeding
After installation of the actuator on the equipment, it is import-
ant that all safety devices such as tie rods or safety cables are
properly reattached.
To purge air from the hydraulic lines, connect them together to
create a closed loop and pump hydraulic fluid through them.
Review the hydraulic schematic to determine which hydraulic
lines to connect. The linear feet and inside diameter of the
hydraulic supply lines together with pump capacity will deter-
mine the amount of pumping time required to fully purge the
hydraulic system.
Bleeding may be necessary if excessive backlash is exhibited
after the actuator is connected to the hydraulic system. The fol-
lowing steps are recommended when a minimum of two gallons
(8 liters) is purged.
1. Connect a 3/16 in. inside diameter x 5/16 in. outside
diameter x 5 foot clear, vinyl drain tube to each of the
two bleed nipples. Secure them with hose clamps. Place
the vinyl tubes in a clean 5-gallon container to collect
the purged oil. The oil can be returned to the reservoir
after this procedure is completed.
2. With an operator in the platform, open both bleed nip-
ples 1/4 turn. Hydraulically rotate the platform to the
end of rotation (either clockwise or counterclockwise),
and maintain hydraulic pressure. Oil with small air bub-
bles will be seen flowing through the tubes. Allow a 1/2
gallon of fluid to be purged from the actuator.
3. Keep the fittings open and rotate the platform in the
opposite direction to the end position. Maintain hydrau-
lic pressure until an additional 1/4 gallon of fluid is
pumped into the container.
4. Repeat steps 2 & 3. After the last 1/2 gallon is purged,
close both bleed nipples before rotating away from the
end position.
TYPICAL CONFIGURATION
OF ACTUATOR