SECTION 5 - BASIC HYDRAULICS INFORMATION & SCHEMATICS
5-12
31215031
Upright Level Cylinder
DISASSEMBLY
NOTE:
Refer to Figure 5-12. Upright Level Cylinder
CONTAMINATION MAY DAMAGE EQUIPMENT. DISASSEMBLE CYLINDER ON A
CLEAN WORK SURFACE IN A DIRT FREE WORK AREA.
1.
Connect a suitable auxiliary hydraulic power source to
cylinder port block fitting.
DO NOT FULLY EXTEND CYLINDER TO THE END OF STROKE. RETRACT CYLINDER
SLIGHTLY TO AVOID TRAPPING PRESSURE.
2.
Operate hydraulic power source and extend cylinder.
Shut down and disconnect power source. Adequately
support cylinder rod, if applicable.
3.
If applicable, remove cartridge-type counterbalance
valve and fittings from cylinder port block. Discard
O-rings.
4.
Place cylinder barrel in a suitable holding fixture.
Figure 5-9. Cylinder Barrel Support
5.
Mark cylinder head and barrel with a center punch for
easy realignment. Using an allen wrench, loosen the cyl-
inder head retainer capscrews and remove capscrews
from cylinder barrel.
Figure 5-10. Marking Cylinder for Alignment
EXTREME CARE SHOULD BE TAKEN WHEN REMOVING THE CYLINDER ROD, HEAD, AND
PISTON. AVOID PULLING THE ROD OFF-CENTER, WHICH COULD CAUSE DAMAGE TO THE
PISTON AND CYLINDER BARREL SURFACES.
6.
Clamp barrel securely. Pull rod assembly and cylinder
head from barrel.
7.
Protect cylinder rod from damage and clamp in a vise or
holding fixture as close to piston as possible.
Figure 5-11. Cylinder Rod Support
MAE33420
PUNCH MARK
CYLINDER HEAD
BARREL
CAPSCREW
Go
to
Discount-Equipment.com
to
order
your
parts
