JLG 3507, Дополнительное руководство по ремонту, Страница: 55 / 180

ASSEMBLY
53 Dana Holding Corporation ASM-0025E - 212 Axle Service Manual
FIGURE 19: Apply tool T1 (See drawing T1 p. 58) to the shaft
on the opposite side of the head (2) and center it on the cylin-
der (3) so that it fits into the piston (5).
NOTE:
Apply a little grease to seals and cylinder.
FIGURE 20: Push the piston (5) into the cylinder for 100 mm
using a plastic hammer.
FIGURE 21: Remove tool T1 (See drawing T1 p. 58) and ap-
ply it to the opposite side of the piston (5).
5
3
T1
5
3
5
3
5
3
2
5
T1
5
2
FIGURE 22: Apply grease to head (2) seals, fit the head onto
the piston and push it into the cylinder (3) using a plastic ham-
mer.
NOTE:
Insert the head as to line it up with the edge of the cylin-
der.
FIGURE 23: Insert the stop ring (4) ensuring that it fits into the
seat of the cylinder (3).
FIGURE 24: Apply pressure to the head using two screwdri-
vers or levers until the head is fastened onto the stop ring (4).
5
T1
2
5
2
3
4
4
3
2
2