JLG 3507, Дополнительное руководство по ремонту, Страница: 119 / 180

ASSEMBLY
117 Dana Holding Corporation ASM-0025E - 212 Axle Service Manual
FIGURE 28: 3-FUNCTION VERSION ONLY
Using the measurements just taken, calculate thickness "S"
of shims (9) as follows: S=(A1+1.5)±(B1+18.4) where:
S=Shim thickness - 1.5 mm=fixed measure of braking discs
clearance - 18.4 mm=fixed measure of Belleville washers.
FIGURE 29: 3-FUNCTION VERSION ONLY
Lubricate the o-rings and install the whole piston (33). Orient
the piston with the help of a lever and push it to end of stroke
with a plastic hammer.
Check that the adjusting stakes (30) are thoroughly inserted
and make sure they perform a sliding motion in relation to
each other.
S
9
10
30
33
CAUTION
FIGURE 30: 3-FUNCTION VERSION ONLY
Insert springs (32) for piston (33) backward movement.
FIGURE 31: 3-FUNCTION VERSION ONLY
Apply Loctite 242 to the thread of screws (31) and tighten.
NOTE:
Tighten the screws with a normal wrench in an alternate
and criss-cross method.
FIGURE 32: 3-FUNCTION VERSION ONLY
Lock screws (31) in a criss-cross method by using a torque
wrench set to a maximum torque of 10 N·m.
Do not exceed the specified torque setting.
33
32
31
31
31
CAUTION