SECTION 3 - CHASSIS, PLATFORM, & SCISSOR ARMS
3-38
31215079
Assembly
1. When assembling steer cylinder and spindle, follow
Removal Steps in reverse.
NOTE:
Apply Medium Strength Threadlocking Compound
to bolts (4, 6, 11). Torque flange bolt (11) to 108 ft. lb.
(147 Nm).
Inspect bushing seals (9). Replace if damaged.
Ensure large thrust washer (14) is installed between
spindle (8) and bottom of axle.
Be certain spindle nut (13) is aligned and seated in
the machined groove on the axle before tightening.
NOTE:
Torque chassis tilt sensor assembly bolts (16) to 106
in. lbs (12 Nm).
•
Oscillating Axle Tilt Sensor (10) -
If this sensor is
not wired correctly, a CANBUS FAILURE - OSCILLAT-
ING AXLE TILT SENSOR fault will appear.
Go
to
Discount-Equipment.com
to
order
your
parts
