SECTION 5 - GENERAL SPECIFICATIONS AND MAINTENANCE
5-28
– JLG Lift –
3121272
8215 LSS ANGLE SENSOR -
OUT OF RANGE LOW
The angle sensor’s reading when the machine
is stowed does not fall within the low end
acceptable range.
Refer problem to a qualified JLG mechanic.
8216 LSS ANGLE SENSOR HAS NOT BEEN CAL-
IBRATED
The Angle Sensor has never been calibrated
and the control system assumes that the plat-
form is overloaded.
Refer problem to a qualified JLG mechanic.
8-2 LSS - Load Sensing System
DTC
FAULT MESSAGE
DESCRIPTION
CHECK
8-4 Elevation Switch
DTC
FAULT MESSAGE
DESCRIPTION
CHECK
84109 ELEVATION SWITCH CONTACTS DIS-
AGREEMENT
The elevation switch is repeating an incorrect
value.
Refer problem to a qualified JLG mechanic.
9-9 Hardware
DTC
FAULT MESSAGE
DESCRIPTION
CHECK
995
POWER MODULE FAILURE - PERSONAL-
ITY RANGE ERROR
A problem has been detected with the power
module.
Refer problem to a qualified JLG mechanic.
996
POWER MODULE FAILURE - INTERNAL
ERROR
A problem has been detected with the power
module.
Refer problem to a qualified JLG mechanic.
