JLG 1932RS/6RS, Руководство по эксплуатации и безопасности

Страница: 47 / 98

SECTION 3 - MACHINE CONTROLS, INDICATORS AND OPERATION
3121272 – JLG Lift – 3-15
then lift down only is permitted. Reduce the weight in the
platform to not exceed the rated workload indicated on
the capacity decal.
Tilt Indicator Warning Light and Alarm
-
(Item 7 - Figure 3-6.)
A red warning light on the control panel illu-
minates and an audible alarm sounds when
the chassis is at or beyond the tilt cutout set-
tings.
IF THE TILT INDICATOR WARNING LIGHT/ALARM IS ACTIVATED WHEN PLAT-
FORM IS RAISED LOWER PLATFORM AND DRIVE TO A SMOOTH FIRM LEVEL
SURFACE.
Horn
- (Item 9 - Figure 3-6.)
This push-button switch, when pressed, per-
mits the operator to warn job site personnel
when the machine is operating in the area.
Low Battery Charge and System Fault
Indicator
- (Item 11 - Figure 3-6.)
This indicator light comes on and stays lit
when the battery charge level is very low ,
indicating the batteries will need recharging
soon.
When indicator light is flashing a system
fault has occurred , possibly stopping
machine operation. Check the MDI indicator on the Ground
Control Station to see if a (DTC) Diagnostic Trouble Code(s) is
displayed. An explanation of DTC codes is shown in Section 5.9.
If the code cannot be cleared by the operator, the machine will
require service by a qualified JLG mechanic.
Alarm
- (Item 5 - Figure 3-6.)
This alarm mounted on the front of the platform control station
will sound for various machine conditions or warnings such as,
system ready chirp or if the machine tilt warning is activated.